Smart Toilet Z-88019 Installation Guide

Features:

• Water tank-less design, saving space
• Intelligent computer control, automatic induction flushing
• Equipped with hot air drying and night lighting
• Optimize water saving and meet environmental protection standards
• Ergonomic design, suitable for various body types

Installation Preparation

Before installing Z-88019, please confirm the following conditions:

• The water pressure requirement is static>0.15Mpa
• The drain outlet should be 300 cm from the wall and 400 mm from the ground
• Power sockets should be conveniently located

Installation Steps

1. Make sure the drainage system is compatible with the wall surface and power supply.
2. Make wall or floor adjustments based on the above dimensional requirements.
3. Connect water pipes and cables to ensure there is no risk of water leakage or short circuit.
4. Secure the toilet and check for stability.
5. Finally, test the water pressure and flushing function of the toilet.

Common installation problems and solutions

During the installation process, you may encounter the following problems:

• Unstable water pressure: Please contact professionals for water pressure testing and adjustment.
• The drain outlet is not aligned: Remeasure and confirm the corresponding position of the drain outlet and the toilet.
• Incompatible power outlet: Make sure the power cord and your home's power source meet safety standards.

Make sure to follow the installation guide strictly to avoid unnecessary damage. If you have any questions, please contact online customer service for support!